Balancer Adapter Cable for Vspeak Variometer Pro upto 28v
The battery balancer connection has to be done by yourself and most balance lead pigtails are available from Nexus Models to complete your lead.
The length of the adapter cables is approximately 20cm.
In battery's with a number of cells up to 4S the voltages of all single cells (and the total battery voltage) can be monitored. In 5S and 6S battery's the VSpeak-Vario only monitors the voltages of the cells 1 .. 3 and the total battery voltage. The battery technology is so advanced, that under normal use the battery's discharge of all cells is uniform, so only small voltage differences between the cells occur. Thus can be closed almost certainly from the voltage monitoring of the cells 1...3 on the voltage of the cells 4, 5 and 6.
For correct measurement of cells and the total voltage a ground connection between the negative terminal of the battery and the negative terminal of the receiver is necessary. For controllers with BEC, this connection is automatically done – BUT NOT in opto-controllers, there you have to make a ground connection separately.
For EH and XH balancer are assembled cables available. For other systems the VSpeak-Balancer connector can be supplied.
Please Note: All images showing a balance connector with this lead is an example of how to wire this lead.
This lead is supplied as open wire to connect to your used battery balance connector. Most balance lead pigtails are available from Nexus Models.
